【Product Introduction】

Mist Eyebrow Printing is a new type of a practical thrush tools, easy to use, it is the use of people to take off the natural physiological radian, combined with the vertical geometry. Aesthetics, color, mechanics. Presented to us in the form of a seal.

Because of eyebrow color, "elegant like fog" natural vivid, so the name "fog Eyebrow print" trademark patent, solve the beauty of the trouble of the thrush, but also for the decorative decoration to provide exquisite eyebrow type, save the trouble of design.

【Physical Map】

【Use method Flow】

One. Scrape out the obvious miscellaneous eyebrows (eyebrow-type eyebrows)

Two. Use the sponge stick to get the eyebrow powder, evenly to the arc surface sponge. To be strong on the first layer, the brow to a little less flutter.

Three. Pick up the support rod, left eyebrow with the left hand, right eyebrow to take with the right hand, the eyebrow printing parallel to the eyebrow, the arc surface close to the eyebrow, the brow line perpendicular to the corner of the eye is placed above, (eyebrows line is parallel to the midline of the nose, can be used as a reference to the brow of the line by their own decision, (but can not be separated from the eyebrow muscle) two eyes far away from the beauty, can be the brow line close to the nose beam one points. Two eyes are too close to the beauty.

Four. Eyebrow relaxation, eye forehead alignment eyebrows line, eyebrow printing close to the eyebrow, do not loosen, with the other hand of the belly surface vertical flat embossed eyebrow printing on the frame, brow to eyebrow place, (at this time, the work can not be relaxed eyebrow old printing or twist eyebrow muscle, otherwise will be printed deformation) do not use too much pressure on the line, persist.

Five. will take the support Rod's hand to liberate, uses the finger vertically presses the eyebrow tail upper frame, must not loosen the shield printing, again both sides of the finger together presses the entire eyebrow print together to loosen together.

Six. Observe the printed eyebrow type, there is a vacancy. Can be used sponge stick small head, stained eyebrow painting, brow too thick, can be used eyebrow brush or cotton swab light, because of the unskilled operation of the place can be used to modify the foundation stained on the modified brush, the lid modified, or the lid reprint.

Seven. Eyebrow type has been identified. Eyebrow-type outside the eyebrow can be fixed at a glance to clean and tidy to catch eyebrow type.

Eight. Then the brow of the other eyebrow line and the position of the eyebrow to the previous one for the standard, lightly marked. Must not be too obvious, put eyebrow printing method ibid.